(i) In this operation, fine-toothed combs continue straightening the fibers until they are arranged with such high degree of parallelism that the short fibers called ‘noils’ are combed out and completely separated.
(ii) This procedure is not done when processing man-made staple fibers because they are cut into predetermined uniform length.
(iii) This operation eliminate, as much as 25% of the original card sliver, thus almost one-fourth of the raw cotton becomes waste.
(iv) The combing process forms a comb sliver made of the longest fibers, which, in then, produces a smoother & more even yarn.
Fig 1.4 Combing (4) Drafting / Drawing
(i) The draw frame has several pairs of rollers, each advance set of which revolves at a progressively faster speed.
(ii) This action pulls the staple lengthwise over each other, thereby producing longer & thinner slivers.
(iii) After several stages of drawing out, the condensed sliver is taken to the slubber, where rollers similar to those in the drawing frame draw out the cotton further. (iv) The slubbing is passed to the spindles, where it is given its first twist & is then wound on bobbins.
Roving
(i) Roving is the final product of several drawing out-operation.
(ii) These bobbins are placed on the roving frame, where further drawing out and twisting take place until the cotton stock is about the diameter of a pencil lead
(iii) To this point, only enough twist has been given the stock to hold the fibers together. (iv) Roving has no tensile strength, it will break apart easily with any slight pull.
